№ 100(6), June, 2014
Public date: 30.06.2014
Archive of journal: Articles count 116, 271 kb
-
IMPROVING THREE-DIMENSIONAL OBJECT VISUALIZATION USER INTERFACE WITH AUGMENTED REALITY TECHNOLOGY
DescriptionThe article describes hardware and software specific issues of implementing augmented reality for improving user interface of visualization of a virtual object. It also defines possible future improvements of the subject
-
RESEARCH AND MODERNIZATION OF CRUSHING AND SORTING EQUIPMENT OF SAND AND SAND-GRAVEL MIXTURE
DescriptionThe object of studying was CMD-108 crusher. The aim of this scientific article is studying kinetic and dynamic parameters of crusher operating devices. As a tool of studying there were used methods of mathematic analysis, theoretic mechanics and physics. As a result of theoretic studies there were defined speeds of various points of the crusher operating devices as well as there were obtained the values of dynamic loads on them and given recommendations on optimization of the crusher operating conditions and its designs. There was also determined an optimum zone of the material crushing from the viewpoint of operating life of the hinged joints of movable jaw enabling to reduce to minimum dynamic impact components of the reactions of the supporting joints of the movable jaw which increases their operating life
-
ANALYSIS OF THE STATE OF OPERATION OF CORPORATE NETWORKS ON THE MODERN STAGE
DescriptionThe article contains the analysis, the method of operation of corporate networks, the graphs definition of the stock of the resource under increasing and decreasing in time the predictive values of the parameter
-
HYBRID OPTIMIZING GRIFFON-VULTURE ALGORITHM BASED ON SWARM INTELLIGENCE MECHANISMS
DescriptionGriffon-vultures with input parameters minimal value for compound functions optimization that change during the time searching hybrid algorithm offered in this article. Researches of its efficiency and comparing analysis with some other systems have been performed
-
THE INFLUENCE OF CONDITIONS OF PRESSING IN FLAX SEEDS ON THE OUTPUT AND QUALITY OF OIL
DescriptionThis article studies technologies of cold pressing in flax seeds of low-linolenic and ordinary sorts. We studied how conditions of flux seeds pressing influence acid and peroxide values of oil as well as fraction of total mass in oilcake. The results of experiment have been mathematically processed
-
Description
The results of theoretical studies presented in this article is intended to familiarize with perspective direction of improving quality of work potato harvesters by improving the working bodies of separation
-
RESULTS OF EXPERIMENTAL STUDIES OF THE DEVICE FOR ENERGY SATURATION OF A FUEL ON DIESEL D-243
DescriptionIn the article we have analyzed the results of measurements of pressure of gases in the combustion chamber and the fuel pressure at the inlet injector diesel D-243 at a processing frequency (acoustic and electromagnetic) fuel 17 kHz
-
Description
This article aims to study the prospects of energy complexes on the basis of renewable energy sources to supply electricity to the stand-alone consumers in different regions of Myanmar. In order to do that territory of Myanmar is divided into some regions according to their amount of renewable energy sources, methods for determining the optimum parameters and operation of energy complex on the basis of renewable energy sources are developed and the cost-effectiveness of those energy complexes in the regional power sector of Myanmar is analyzed
-
THE IMPACT OF DIFFERENT SUBSTRATS ON RIZOPLANE MICROFLORA OF PELARGONIUM ZONALE IN PROTECTED GROUND
DescriptionThe article studies the impact of different substrats on rizoplane microflora of pelargonium zonale in protected ground
-
Description
In order to obtain fortified feed additives and malt the use of activated water solutions was studied