Northern-Caucasian Scientific Research Institute of Mechanization and Electrification of Agriculture
Author list of organization
List of articles written by the authors of the organization
-
INFLUENCE OF PREDECESSORS AND TECH-NOLOGIES OF PROCESSING ON DEVELOP-MENT OF WEEDS
DescriptionIssues related to the contamination of crops are topical and very relevant. All this fully applies to the main crop produced in the South of Russia – winter wheat. In this regard, the presented results of studies of the influence of predecessors and tillage technologies on the development of weeds in the cultivation of winter wheat are relevant. Experimental studies were carried out in conditions of many years of experience located in the FEDERAL state scientific institution «ANTS «Donskoy». The influence of different methods of sowing (ordinary, scattered, belt) and technologies of tillage (dumping, non-dumping, surface, small) on infestation of winter wheat is considered. It is established that the least amount of weed plants is provided at scattered sowing on the background of deep tillage. The main treatment at a depth of 18-20 cm reduces the number of weeds by 47% in comparison with the surface (8-10 cm), and the scattered sowing reduces their number by 80%, since weeds are in more severe conditions compared to winter wheat, the rapid development of which contributes to the optimal nutrition area. Of the predecessors, the most acceptable is the steam with the number of weeds 7-25 PCs / m2, which is several times less than after peas, or corn after silage
-
RESOURCE CONSERVATION IN THE PRODUCTION OF SPRING BARLEY
DescriptionThe article discusses the possibilities and presents the results of research on the cultivation of spring barley with different production technologies in conditions of insufficient and unstable wetting of the south of Russia. Experimental studies were carried out in a stationary experiment with a four-field crop rotation with different variants of tillage (dump, flat-cut, layered, without tillage – no-till). It is established that the most expensive is the waste treatment of the soil (PN-5-35), and the least expensive is the technology excluding the impact on the soil. At the same time, the operating costs of labor and fuel consumption at no-till are lower, respectively, by 82-107, 23-48, 131-188% in comparison with traditional types of technology. Hectare fuel consumption with zero technology is 131-188% less than with traditional technologies and amounted to 22.8 kg / ha. The cost of production of spring barley using no-till is 8-41% lower compared to flat-cut, layer-by-layer, and dump technology and amounts to 285 rubles per cent. Calculated per 1 hectare, labor costs, fuel consumption, wages, fuel costs, deductions for renovation and repairs, as well as total operating costs for traditional basic tillage technologies increase, respectively, 1,23-1,48; 2,31-2,88; 1,30-1,56; 3,1-3,81; 1,65-1,85; 1,81-1,96; 1,83-2,09 times compared with no-till. The use of spring barley cultivation technology that excludes impact on the soil provides a fairly high efficiency even at lower yields
-
EFFICIENCY OF USING COMBINED UNITS WHEN PREPARING SOIL UNDER WINTER CROPS
DescriptionIssues associated with the use of combined units in the preparation of the soil are relevant and of scientific and practical interest. Relevance increases when it comes to the cultivation of the main crop - winter wheat. In this regard, the presented results on the effectiveness of the use of combined units in the preparation of soil for winter crops are important. They are important primarily from a practical point of view. Experimental studies were conducted in the conditions of many years of stationary experience in the FSUE "ANC" Donskoy ", Zernograd, Rostov Region and in the Krasnodar region, LLC "Step". The efficiency of the use of combined units KUM-4, APK-4, developed at SKNIIMESH, now FSUE “ANC “Donskoy” in the cultivation of winter barley and winter wheat is considered. The technological process of tillage using combined units consists of several technological operations performed simultaneously. Disk working bodies chop plant residues and destroy weeds. At the same time, a network of cracks in the underlying soil horizons is laid. Next are flat-cutting working bodies that loosen the soil already at the set depth. There is a cutting of the root system of weeds, loosening the remaining non-loosened soil layer to the required depth, the formation of a flat bottom of the “furrow”, the separation of erosion-hazardous soil particles to the bottom of the furrow. Next, a roller - a compactor - compactor enters the work, which provides regrinding of soil lumps on the surface and subcompaction of the treated layer. The last in the process chain is a mulch roller, which ensures the formation of a compacted seed bed for seeds with simultaneous mulching of the compacted soil layer. The use of combined units in the technologies of cultivation of winter barley and wheat allowed to achieve a reduction in the number of technological operations by 1,5-2,5 times, an increase in the productivity of winter wheat by 0,4 t / ha (9%), a reduction in fuel consumption by 40%, operating costs 1,4 times with the economic effect of 1500 rubles / ha and the profitability of production of 140%
-
OPPORTUNITIES TO REDUCE OPERATING COSTS IN THE PRODUCTION OF LEGUMINOUS CROPS
05.20.00 Processes and machines of agroengineering systems
DescriptionThe article considers the possibility of reducing the cost of tillage in the production of grain crops. The most important economic characteristic of production is operating costs. In terms of agricultural production, they represent the amount of contributions to wages, depreciation, repairs, and the cost of fuel, lubricants and other consumables. In this regard, the aim of the research was to determine the dynamics of operating costs in the production of legumes. Determination of the dynamics of operating costs was carried out on the basis of the results of studies of energy-saving technologies in a stationary experience. Variants of processing of the soil on the conventional technology was layered subsurface tillage combined unit, UNS-3, the layered subsurface tillage unit CUO-2 and conventional tillage (PN-5-35). No provision was made for zero tillage technology. As a result of the research it was found that on pre-sowing tillage and sowing, the value of operating costs varies for the crops under consideration, but has almost the same values (within each crop) for the methods of the main tillage. More preferable for this type of work is zero tillage, as it provides 21-29% lower operating costs due to direct sowing of crops. The highest operating costs for all the crops under consideration are observed in the main tillage. In the same technological period of work operating costs are the most variable. Thus, depending on the technology of the tillage when growing winter wheat, they change within 117,2-5229,2, the production of spring barley - to 167,8-4517,4 and in the production of peas – to 136,6-4517,4 thousand rubles
-
TECHNOLOGICAL ASPECTS OF SOIL DEPLOYMENT
DescriptionThe article presents the results of research on the impact of tillage technologies on the value of its density in the cultivation of winter wheat in conditions of insufficient and unstable wetting of the south of Russia. Experimental studies were carried out in the conditions of a long-term stationary experiment with a four-field crop rotation with different variants of tillage (dump, layer-by-layer, small, surface). The soil density was fixed at spring tillering of winter wheat and at the end of the growing season. Conducted analysis of variance shows that the soil has relaxation abilities, i.e. over time, it restores its properties by compaction ability, since studies conducted during the period of tillering of winter wheat show that Ffact. Ftable. (5,794,76), i.e. methods of treatment have an impact on soil compaction, which cannot be said for the case at the end of the growing season of winter wheat. The ability to restore its properties is a remarkable property of the soil, as it prevents them from over-compaction. The energy intensity of the compacted soil treatment increases to 30%, while the degree of crumbling is significantly reduced and its lumpiness increases. The most fundamental way to reduce the density of the soil is its timely loosening by working bodies of agricultural tools. Tillage methods affect soil density, the correlation coefficient between tillage methods and soil density varies between 0,929-0,979. The most radical way of soil decompression is exposure to it by a certain type of working bodies
-
THE RATIONALE FOR THE USE OF COMBINED UNITS IN THE CULTIVATION OF WINTER WHEAT
06.01.01 General agriculture, crop production (agricultural sciences)
DescriptionIssues related to the use of combined aggregates in soil preparation are relevant and of scientific and practical interest. The relevance is increased when it comes to the cultivation of the main crop – winter wheat. In this regard, the presented results on the efficiency of using combined aggregates in preparing soil for winter crops are important primarily from a practical point of view. Experimental studies were conducted in the conditions of long-term stationary experience in the Federal state budgetary institution «Agrarian Science Center «Donskoy», Zernograd, Rostov region. The article considers the efficiency of using the combined unit APK-4, developed in "SKNIIMESH" now Federal state research institution of the «Agrarian Science Center «Donskoy» in the cultivation of winter wheat. The structural and technological scheme of a combined unit, the technological process of which consists of several technological operations performed at the same time, is justified. Disk working bodies crush plant residues and destroy weeds. This creates a network of cracks in the underlying soil horizons. Next, there are flat-cutting working bodies that loosen the soil to a set depth. The root system of weeds is pruned, the remaining loosened soil layer is loosened to the required depth, the formation of a smooth bottom of the "furrow", and the separation of erosive soil particles to the bottom of the furrow. Next, the roller starts working – a lump-crushing sealer, which provides crushing of soil lumps on the surface and sub-compaction of the treated layer. The last in the technological chain is a mulching roller, which provides the formation of a compacted seedbed for seeds with simultaneous mulching of the compacted soil layer. The use of the combined unit in the technology of winter wheat cultivation allowed to reduce the number of technological operations by 1,5-2,5 times, increase the productivity of winter wheat by 11-13% and the cost of production by 10,4-18,3 %